esenfrpt-pt
Customer access

Sintering

DESCRIPTION

Not only for work with natural teeth but also for frameworks on implants, Bioinnovación Dental offers you the possibility to perform your work on sintered cobalt chromium.

It is particularly recommended for simple frameworks, from crowns to bridges, with no limit as to the number of units. This technique is suitable for cemented restorations on natural teeth as it provides an ideal marginal fit for any type of carving. Furthermore, for implant work, it offers a very good quality/cost relationship.

PREPARATION

Preparation of the ceramic veneer.

  1. Go over the framework with a green stone.
  2. Sand with aluminium oxide between 110 – 150 μm, (pressure 2.5-3 bars).
  3. Clean the surface with a steam jet.
  4. Oxidation: Maintain for 5 minutes at 900ºC under vacuum, maximum temperature rise (55°C/min).
  5. Then sand with aluminium oxide at 250 μm/3-4 bar and clean the surface again with a steam jet.
  6. Apply the bonding layers and opaquer layers as normally performed in your laboratory.
  7. Then apply the different ceramic veneers according to the manufacturer’s instructions.

Download technical data sheet

– TABLE OF SOLUTIONS –

Sintex Milled Sintered Zirconia Disilicate PMMA
NATURAL TOOTH
CROWN / ABUTMENT
BRIDGE
BAR
HYBRID

On interface