Preparation of the ceramic veneer.

1. Go over the framework with a green stone.
2. Sand with aluminium oxide between 110 – 150 μm, (pressure 2.5-3 bars).
3. Clean the surface with a steam jet.
4. Oxidation: Maintain for 5 minutes at 900ºC under vacuum, maximum temperature rise (55°C/min).
5. Then sand with aluminium oxide at 250 μm/3-4 bar and clean the surface again with a steam jet.
6. Apply the bonding layers and opaquer layers as normally performed in your laboratory.
7. Then apply the different ceramic veneers according to the manufacturer’s instructions.